- 101 - © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.14.3 GS1 DataBar Expanded
3.14.4 Convert GS1 DataBar to UPC/EAN/JAN
This parameter only applies to GS1 DataBar-14 and GS1 DataBar Limited
symbols not decoded as part of a Composite symbol. Scan Enable Convert
GS1 DataBar to UPC/EAN/JAN to strip the leading '010' from DataBar-14
and DataBar Limited symbols encoding a single zero as the first digit, and
report the bar code as EAN-13.
For bar codes beginning with between two and five zeros, this strips the
leading '0100' and reports the bar code as UPC-A. The UPC-A Preamble
option that transmits the system character and country code applies to
converted bar codes. Note that neither the system character nor the check
digit can be stripped.
Enable GS1 DataBar Expanded*
Disable GS1 DataBar Expanded
Enable Convert GS1 DataBar to UPC/EAN/JAN
Disable Convert GS1 DataBar to UPC/EAN/JAN*
To Next Page
Loading...
