Unitech MS282 - Code 128 Emulation

-115- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.17.3 Code 128 Emulation
Enable this parameter to transmit data from certain MicroPDF417 symbols
as Code 128. You must enable AIM Code ID Character (1) for this
parameter to work.
Enable Code 128 Emulation to transmit these MicroPDF417 symbols with
one of the following prefixes:
]C1 if the first codeword is 903-905
]C2 if the first codeword is 908 or 909
]C0 if the first codeword is 910 or 911
Disable Code 128 Emulation to transmit these MicroPDF417 symbols with
one of the following prefixes:
]L3 if the first codeword is 903-905
]L4 if the first codeword is 908 or 909
]L5 if the first codeword is 910 or 911
Scan one of the following bar codes to enable or disable Code 128
Emulation.
Note: Linked MicroPDF codewords 906, 907, 912, 914, and 915 are not supported. Use
GS1 Composites instead.
Enable Code 128 Emulation
Disable Code 128 Emulation *