Vaisala DRYCAP DMT143 - Show Analog Output Mode; Show Firmware Version; Show Firmware Information

?
DMT143 1.0.2
Serial number : H1220011
Batch number : H1210003
Sensor number : G3320000
Sensor model : DRYCAP180D
Cal. date : 20120412
Cal. info : VAISALA/HEL
Time : 01:38:00
Serial mode : STOP
SCI Baud P D S: 19200 N 8 1
Output interval: 1 S
Serial delay : 30
Address : 0
Pressure : 1.013 bar
Filter : 0.100
7.5.2 Show Analog Output Mode
Use the AMODE command to show the analog output mode:
AMODE<cr>
Example:
amode
Ch1 output : 4 ... 20 mA
7.5.3 Show Firmware Version
VERS<cr>
Example:
vers
DMT143 1.0.2
7.5.4 Show Firmware Information
SYSTEM<cr>
Example:
system
Device Name : DMT143
Copyright : Copyright (c) Vaisala Oyj 2012. All rights reserved.
SW Name : DMT143
SW date : 2012-05-10
SW version : 1.0.2
Chapter 7 – Serial Communication
45