7.9.4 Set Serial Line Response Time
With the SDELAY command you can set delay (response time) of the serial line, or view the
currently set delay value.
SDELAY [delay]<cr>
Syntax Description
delay
Serial line delay, range 0 … 255. One unit of delay corresponds to
4 milliseconds.
Example (set delay to 120 milliseconds):
sdelay 30
Serial delay : 30
7.10
Other Commands
7.10.1 Opening the Transmitter in POLL Mode
Use the OPEN command to connect to a transmitter that is in POLL mode.
OPEN [address]<cr>
Syntax
Description
address
Transmitter address, range 0 ... 255.
Example (target transmitter in POLL mode, with address 5):
open 5
DMT143 5 line opened for operator commands
7.10.2 Closing the Connection to a Transmitter in POLL Mode
The CLOSE command closes the connection to a transmitter.
CLOSE<cr>
Example:
close
line closed
Chapter 7 – Serial Communication
59
To Next Page
Loading...
