Vaisala DRYCAP DMT143 - Reset Transmitter; Restore Factory Settings

alarm on off
LED display : ON
Alarm display : OFF
Setpoint Td(°C): -40.00
Example (turn o the LED completely):
alarm off
LED display : OFF
More Information
‣
Alarm LED (page 20)
7.10.4 Reset Transmitter
Use the RESET command to reset the transmitter.
RESET<cr>
When the RESET command is given, the transmitter will restart as if it had just been powered
on. All transmitter settings are retained. The serial line mode of the transmitter will be set to
the mode that was set using the SMODE command.
7.10.5 Restore Factory Settings
Use the FRESTORE command to restore the transmitter to its factory configuration. All user
settings will be lost.
FRESTORE<cr>
After using the FRESTORE command, reset the transmitter using the RESET
command.
Chapter 7 – Serial Communication
61