MC095 - MCP-8 Control Unit Section 4 - Programming
51
Tipsealer
The Tipsealer function places the nozzles onto the Tipsealer Pad during brief workflow stops, to prevent the glue from
drying out.
Tipsealer Control supports 3NC, 4NC, 3NCR and 4NCR glue
stations (3NCR and 4NCR are reversible).
This is only available on Tri-Valve MCP-8 controls.
Selecting the Setup Menu Button opens the Setup Menu.
On the Setup Menu, make sure the Application is set to “Corrugated.”
The factory-default application setting is “Folding Carton,” which
does not employ the Tipsealer feature. The application must be set
to “Corrugated” to access the “Glue Station Setup.”
Press “Glue Station Setup” to select.
Setup
To Next Page
Loading...
Need help?
General