Section 4 - Programming MC095 - MCP-
52
Tipsealer - Continued
Select the Glue Station Type, either Operator Side (OS) or Drive Side (DS), that you wish to configure.
When the station is selected, a sub-menu will open, allowing selection of a specific configuration to match the system.
Select the desired configuration and touch “Apply.”
Tipsealer Control:
Allows settings to be turned on or off by pressing the command. When turned on, options below “Tipsealer Control”
will be accessible. In addition, the icon will show if the valves are in the tip sealing position or in the run position.
To Next Page
Loading...
Need help?
General