Section 4 - Programming MC095 - MCP-
54
Tipsealer - Continued
Output Error Mode:
When an error occurs, the controls allow an alarm to activate, or for a relay to shut down the system until the error is
corrected and the system restarted.
Error Mode output options:
Off
Alarm 1
Alarm 2
Relay
Jogg on Restart:
“Jogging” dispenses a series of glue dots, rather than a continuous line. This helps to clear the nozzles of dried glue
and make sure the valves are dispensing correctly. “Jogg on Restart” sets the number of boxes (0-25) that will receive
a “jogg” pattern, following a restart, before glue again dispenses in the normal, programmed pattern.
To Next Page
Loading...
Need help?
General