Adjusting rear 3 point control lever friction
IMPORTANT:
Make sure that the engine is OFF and that the 3
point hitch is in the lowest position.
If the position control lever does not stay in the set
position, tighten the position control lever fastener
(I) until the lever stays in position.
If the draft control selector does not stay in the set
position, tighten the draft control lever fastener (H)
until the lever stays in position.
GUID-FA47EE38-7E01-4596-ACA6-0DB7835FCB3D-high.jpg [High]
Fig. 111
3. Operation
F Series 107
39940211 (555124)
To Next Page
Loading...
