Valtra F Series User Manual

Fault code Description
E044 PTO Main Valve stuck open
E045 PTO Clutch low pressure
E046 PTO Output Shaft Speed signal failure
E047 Cruise Control SET2 Switch short circuit to GND or stuck
E141 EEPROM corrupted
E142 MMC to SMC communication error
E143 MMC and SMC SW version are dierent
E144 MMC dead or not responding
E145 Error on CAN BUS
E148 4WD Steering Switch short circuit to Vbatt or stuck
E150 4WD Steering Angle Out of Range
E152 Front PTO HSD Feedback error
E154 Wheel Speed Sensor Out of Range
Transmission Control Unit
Error Code Description
E060 Transmission Electronic Control Unit internal failure
E061 Transmission Electronic Control Unit internal failure
E062 Historical data replaced corrupted
E063 FLASH MEMORY calibration parameters corruption
E064 FLASH MEMORY writing failure
E065 Can bus physical support or communication failure
E066 Transmission Electronic Control Unit supply voltage is under 9V
E067 Transmission Electronic Control Unit supply voltage is over 16V
E068 Sensor supply voltage is under 4.5V
E069 Sensor supply voltage is over 5.5V
E070 Overcurrent detected on Forward Low Clutch
E071 Overcurrent detected on Forward High or Reverse clutch
E072 Overcurrent detected on main ring valve HS supply pin
E073 All outputs overcurrent
E074
FNR Lever is applying Forward and Reverse signals simultaneously to Transmission
Electronic Control Unit
E075
FNR Lever is applying Forward and Neutral signals simultaneously to Transmission
Electronic Control Unit
E076
FNR Lever is applying Neutral and Reverse signals simultaneously to Transmission
Electronic Control Unit
E077
FNR Lever is applying simultaneously Forward, Neutral and Reverse signals to
Transmission Electronic Control Unit
4
6. Troubleshooting
242 F Series
39940211 (555124)

Valtra F Series Specifications

General

Brand	Valtra
Model	F Series
Category	Tractor
Language	English