Valtra F Series

Error Code Description
E078
PWM benches supplied with FNR lever in Neutral position or clutch pedal
completely pressed
E080 Clutch pedal angular sensor output voltage is too high.
E081 Clutch pedal angular sensor output voltage is too low
E082
Clutch pedal angular sensor signal is under stroke minimum value (lower than 100
dgt)
E083
Clutch pedal angular sensor signal is over stroke maximum value (higher than 990
digit)
E084
Clutch pedal angular sensor and switch signals are not consistent (switch pressed
signal at stroke over 20% or switch not pressed signal at 0% of stroke)
E085 Dierential pressure presence detected without engine being on
E086 Dierential pressure detected on filter with engine on and oil temperature over 20°C
E087 Main ring line low pressure (less than 7 bar)
E088 Clutches main ring pressure presence detected without engine being on
E089
Clutches main ring pressure presence detected without valve being powered and
engine on
E090 Oil temperature is under –20 °C
E091 Oil temperature is over 120 °C
E092 Oil temperature sensor signal too high
E093 Oil temperature sensor signal too low
E094 Forward High clutch valve coil no current feedback with command
E155 Forward high clutch - high current
E095 Forward High clutch valve coil current feedback detected when valve is not supplied
E096 Forward High clutch valve coil dierence between measured and reference current
E097 Forward Low clutch valve coil no current feedback with command
E156 Forward low clutch - high current
E098 Forward Low clutch valve coil current feedback detected when valve is not supplied
E099 Forward Low clutch valve coil dierence between measured and reference current
E100 Reverse clutch valve coil no current feedback with command
E157 Reverse clutch - high current
E101 Reverse clutch valve coil current feedback detected when valve is not supplied
E102 Reverse clutch valve coil dierence between measured and reference current
E103
Forward High clutch pressure sensor signal over maximum value (higher than 940
digit)
E104
Forward High clutch pressure sensor signal under minimum value (lower than 40
digit)
E105 Forward High clutch pressure lower than 0.250 bar when pressure requested
E106 Forward High clutch pressure over 0.9 bar when clutch is not activated
E107 Forward High clutch pressure reference and measure dier of 0.5 bar
4
6. Troubleshooting
F Series 243
39940211 (555124)