VAMP 265 - Page 116

3.8 Combined overcurrent status
3 Supporting functions
Technical description
116
VAMP 24h support phone +358 (0)20 753 3264
VM265.EN011
Parameter
Value
Unit
Description
Note
LINE FAULT
FltL1
FltL2
FltL3
0
1
Fault (=trip) status for each
phase.
0=No fault since fault
ClrDly
1=Fault is on
Oct
0
1
Combined overcurrent trip
status.
FltL1=FltL2=FltL3=0
FltL1=1 orFltL2=1 or
FltL3=1
LxTrip
On
Off
„On‟ Event enabling for
FltL1…3
Events are enabled
Events are disabled
Set
LxTripOff
On
Off
„Off‟ Event enabling for
FltL1…3
Events are enabled
Events are disabled
Set
OCTrip
On
Off
„On‟ Event enabling for
combined o/c trips
Events are enabled
Events are disabled
Set
OCTripOff
On
Off
'Off' Event enabling for
combined o/c starts
Events are enabled
Events are disabled
Set
IncFltEvnt
On
Off
Disabling several events of
the same fault
Several events are enabled
*)
Several events of an
increasing fault is disabled
**)
Set
ClrDly
0 ... 65535
s
Duration for active alarm
status FltL1, Flt2, FltL3
and OCt
Set
Set = An editable parameter (password needed)
*) Used with IEC 60870-105-103 communication protocol. The alarm screen
will show the latest if it's the biggest registered fault current, too. Not used
with Spabus, because Spabus masters usually don't like to have unpaired
On/Off events.
**) Used with SPA-bus protocol, because most SPA-bus masters do need an
off-event for each corresponding on-event.