8.6 External I/O extension modules
VAMP 24h support phone +358 (0)20 753 3264
8.6. External I/O extension modules
8.6.1. External LED module VAM 16D
The optional external VAM 16D led module provides 16 extra
led-indicators in external casing. Module is connected to the
serial port of the relays front panel. Please refer the User
manual VAM 16 D, VM16D.ENxxx for details.
8.6.2. External input / output module
The relay supports an optional external input/output modules
used to extend the number of digital inputs and outputs. Also
modules for analogue inputs and outputs are available. The
following types of devices are supported:
Analog input modules (RTD)
Analog output modules (mA-output)
Binary input/output modules
EXTENSION port is primarily designed for IO modules. This
port is found in the LOCAL connector of the relay backplane
and IO devices should be connected to the port with VSE003
adapter.
NOTE! If ExternalIO protocol is not selected to any communication port,
VAMPSET doesn’t display the menus required for configuring the IO
devices. After changing EXTENSION port protocol to ExternalIO, restart
the relay and read all settings with VAMPSET.
To Next Page
Loading...
