VAMP 265 - Menu Structure of Protection Functions

2.2 Local panel operations
2 Local panel user interface
Operation and configuration
instructions
14
VAMP 24h support phone +358 (0)20 753 3264
VM265.EN011
Main
menu
Number of
menus
Description
ANSI code
Note
Prg7
3
7th programmable stage
4
Prg8
3
8th programmable stage
4
If2>
3
Second harmonic O/C stage
51F2
4
CBFP
3
Circuit breaker failure protection
50BF
4
CBWE
4
Circuit breaker wearing supervision
4
CTSV
1
CT supervisor
4
CT’SV
1
CT’ supervisor
4
ArcI>
4
Optional arc protection stage for phase-
to-phase faults and delayed light signal.
50ARC
4
ArcIo>
3
Optional arc protection stage for earth
faults. Current input = I01
50NARC
4
ArcIo2>
3
Optional arc protection stage for earth
faults. Current input = I02
50NARC
4
OBJ
11
Object definitions
5
Lgic
2
Status and counters of user's logic
1
CONF
10+2
Device setup, scaling etc.
6
Bus
13
Serial port and protocol configuration
7
Diag
6
Device selfdiagnosis
Notes
1
Configuration is done with VAMPSET
2
Recording files are read with VAMPSET
3
The menu is visible only if protocol "ExternalIO" is selected for one of the
serial ports. Serial ports are configured in menu "Bus".
4
The menu is visible only if the stage is enabled.
5
Objects are circuit breakers, disconnectors etc.. Their position or status can
be displayed and controlled in the interactive mimic display.
6
There are two extra menus, which are visible only if the access level
"operator" or "configurator" has been opened with the corresponding
password.
7
Detailed protocol configuration is done with VAMPSET.
2.2.2. Menu structure of protection functions
The general structure of all protection function menus is
similar although the details do differ from stage to stage. As an
example the details of the second overcurrent stage I>> menus
are shown below.