Vatech Smart Plus PHT-35LHS Installation Manual

1. Introduction
Smart Plus (PHT-35LHS) Installation Manual 5
English
Locations of the Emergency Stop Switch and the Main
Power Switch
 Make sure to read and fully understand the installation
instructions before installation. The installer must
confirm that the system is installed according to the
instructions provided by this manual and perform the
appropriate procedures therein.
 If the equipment has been stored at temperatures of
below 10℃(50℉) for more than a couple of hours,
allow the equipment to reach room temperature before
applying mains voltage.
 Installation and related work must only be performed by
people authorized by VATECH.
 DO NOT connect any items or equipment to this
system that are not part of the system: IEC60601-1-1
(3rd edition: 2005).
 Any equipment not approved by VATECH must comply
with the applicable standards: IEC 60950-1 (2nd
edition: 2005) for IT equipment (Ex: PC) and IEC
60601-1 (3rd edition: 2005) for medical electrical
equipment.
 All operators of this equipment are responsible for
ensuring that the requirements outlined in IEC 60601-1-
1 (3rd edition: 2005): Safety Requirements for Medical
Electrical Equipment are fully met to ensure the safety
of patients, operators, and the environment.
 Never touch-sensitive areas such as sensors during
installation. These areas are indicated at the
appropriate stages during the installation procedures.
 The use of wireless phones may interfere with the
operation of this equipment.
 Use an ESD (electrostatic sensitive device) wristband
during installation and connect it to a ground wire.
 Touch a ground point to discharge static electricity
before handling PCB boards.
Emergency Stop Switch
Main Power Switch

Vatech Smart Plus PHT-35LHS Specifications

General

Brand	Vatech
Model	Smart Plus PHT-35LHS
Category	Medical Equipment
Language	English