VECTRIX VX-2 SERVICE MANUAL
Regen Throttle Adjustment Procedure
Note
: Key must be in “ON” position and Kill Switch in the “OFF” position
1. Remove the right handlebar end cap. Refer to Handlebar End Cap and Hand Grip
Replacement.
2. Slightly loosen the set screw (1).
3. To determine the current position of the Throttle, squeeze the left side brake lever and using
a large rubber band or similar device secure the lever in the squeezed position, and observe the
needle position.
4. To determine the correct position of the Throttle, squeeze the right side brake lever and
observe the reading.
Note
: The neutral position of the throttle is 615-639. The ideal setting for this adjustment is 625.
5. Release the right lever and adjust the screw (2) until the readings are the same.
6. Remove the large rubber band or similar to release the left side brake lever.
7. Slightly tighten the set screw; this will secure the screw from moving.
8. Install the right handlebar end cap.
Version 1.0/May 2011
VECTRIX, LLC
To Next Page
Loading...
