vii
Remote Control (Cont.)
Using the Remote Control
To use the remote control, point it towards the remote sensor at the front of
the TV.
The remote control has a range of up to approximately five metres (5m)
from the TV at an angle of up to 30 degrees each to the right and left of the
sensor. The remote control will not operate if its path is blocked.
NOTES:
• Do not drop, step on or otherwise impact the remote control as this may
damage the parts or lead to a malfunction.
• The operating distance may vary according to the brightness of the room.
• Do not point bright lights at the remote control sensor.
• Do not place objects between the remote control and the remote control
sensor.
• Do not use this remote control while simultaneously operating a remote
control of other devices.
Remote Control Preparation
• Install the batteries in the back of the remote control, ensuring to match up
the polarity markings (+/-).
• The batteries should last for around one year, depending on how often they
are used.
• If the remote control does not work when operated near the TV, replace the
batteries.
NOTE: Remove the batteries if the remote control is not going to be used for
a long time.
Pairing the Remote Control and the Receiver
If you get a new/replacement remote control, you will need to pair it with the
receiver.
1. Press and hold the OK button and the MUTE button for about three
seconds. The remote control light will turn on and then flash quickly, as it
enters pairing mode.
2. Turn on the USB receiver and wait for about three seconds. The
remote control light will turn on and flash three times. Once pairing has
successfully occurred, the remote control light will turn off.
To Next Page
Loading...
