V-Touch AFAD
MAN-13
User’s Manual
37 Version 2.1
To use the Flagger-Mac in solo mode, with 1 wireless remote, 1 Flagger-Mac:
Figure 6-2 Solo operation mode
1 Make sure that the work area has been evacuated. To raise the gate, press on your
wireless remote. It immediately rises and the yellow light is flashing.
2 To lower the gate, press . The yellow flashing light becomes continuous, then turns red,
and the gate lowers.
6.3 Duo Mode
In this mode, a flagger controls 2 AFADs. Each Flagger-Mac has a number that corresponds to the
button on the wireless remote. That same wireless remote must be paired with the 2 Flagger-Macs
(see section 7.2.2 Wireless Remote
).
To use the Flagger-Mac in duo mode, with 1 flagger which controls the 2 Flagger-Macs:
Figure 6-3 Duo operation mode with one flagger
In this mode, a flagger controls both Flagger-Macs.
1 Make sure that the work area has been evacuated. To raise the gate, press on your
wireless remote. It immediately rises and the yellow light is flashing.
2 To lower the gate, press . The yellow flashing light becomes continuous, then turns red,
and the gate lowers.
3 To raise the gate of the 2
nd
Flagger-Mac, press . It immediately rises and the yellow light is
flashing.
To Next Page
Loading...
