Configuration Parameters D-9
Appendix D: Using the Configuration File
Edge 5000 Installation / Configuration Guide
VOIP line1_type ~
linen_type
Defines the type of line. The n variable is the line button and can
be from 1 to the max_line_num.
Valid values are as follows:
•
private: Calls to the line are presented to all
appearances of the line but, an active call is visible
and accessible through the original endpoints
involved in setting up the call.
• shared (BLA): Calls to the line are presented to all call
appearances of the line and are visible and
accessible by all authorized endpoints.
• dss: a BLA except no outgoing call access is
provided. The users can call to the covered
extensions (Direct Station Selection) and answer
incoming calls. The extension number must set in the
linen_extension field.
Default is private.
line1_extension ~
linen_extension
The associated extension number, which must be assigned for
DSS line types only. The n variable is the line button and can be
from 1 to the max_line_num.
The valid value is the extension number.
The default is blank.
line1_ring_type~
linen_ring_type
Specifies the ring type for the line. The n variable is the line
button and can be from 1 to the max_line_num. Ring type can
be a value from -1 to 4, 101 to 105, or 201 to 205:
• 1, use the default ring type
• 0, ringer off
• 1-4, ring type 1 to 4 (tone ring),
• 101-105, ring type 101 to 105 (wav file ring),
• 201-205, ring type 201 to 205 (user defined ring),
Valid values are -1 or 0 to 4, 101 to 105, or 201 to 205.
The default is -1.
line1_delayed_ring~
linen_delayed_ring
Specifies a delay in the audible ring for the line. The n variable
is the line button and can be from 1 to the max_line_num.
Delayed ring is adjustable from 0 to 10 seconds in 1-second
increments.
Valid values are 0 to 10 seconds.
The default is 0.
Section Field Name Description
To Next Page
Loading...
