Configuration Parameters D-17
Appendix D: Using the Configuration File
Edge 5000 Installation / Configuration Guide
CALL caller_id_blk Controls caller ID blocking. When enabled, the phone sends the
anonymous caller id.
Valid values are enable or disable.
The default is disable.
anonymous_call_blk Controls blocking incoming calls with an anonymous caller id.
Valid values are enable or disable.
The default is disable.
call_waiting Controls visual notification of incoming call while busy.
Valid values are enable or disable.
Default is enable.
call_waiting_tone Controls audible notification when Call Waiting is enabled
Valid values are enable or disable.
Default is enable.
call_hold_ringback Sets Held call ringback. If a user returns to idle with a call on
hold, the held line will ring.
Valid values are enable and disable.
Default is enable.
msg_waiting_tone Controls stutter dial tone when there is a message waiting.
Valid values are enable or disable.
Default is enable.
auto_answer Controls answering an incoming call automatically activating the
speakerphone or headset.
Valid values are enable or disable.
Default is enable.
call_direct Controls Hotline/Warm-Line operation. Going off-hook
automatically places a call to the designated party.
Valid values are enable or disable.
Default is disable.
call_direct_number Defines the destination for a direct call.
Valid value is extension number.
The default is blank.
call_direct_timer Sets the delay for Warm Line operation. After the timer expires,
the direct call is made. Set to zero (0) for Hotline.
Valid values are 0 to 10 seconds delay.
Default is 5.
Section Field Name Description
To Next Page
Loading...
