Examples
To update the firwmare, enter the following command.
cli->fwupdate update
Initiating …
Uploading Image ...
Upload Complete!
Checking Image ...
Image Validated!
Updating Image to Devices …
Updating Image to RPC2 Card ...
Firmware Update Success!
Firmware Update Complete!
Card is rebooting ...
CLI will be disconnected, please re-login after some time.
NOTE: If the current setting is correct, the firmware is updated . If the current setting is not correct, you are
prompted to correct parameters and try again.
To configure the FTPsettings where the firmware is stored, enter the following commands.
Vertiv | RPC2™ Communications Module Command Reference Guide | 17
To Next Page
