<lock_state>
lock
unlock
<power_state>
on
off
<critical_state>
critical
non-critical
Examples
To view the state of all receptacles, enter the following command.
cli->receptaclestate
To lock a receptacle, enter the following command.
cli->receptaclestate <pdu.branch.receptacle>lock
To turn on a receptacle, enter the following command.
cli->receptaclestate <pdu.branch.receptacle>on
To switch a receptacle to a critical state, enter the following command.
cli->receptaclestate <pdu.branch.receptacle> critical
2.29 sensor
Type sensor to display the following information:
• Sensor reported metered values (temperature, humidity) and state of contacts (door, contact sensors) at the
PDU level
• The address of the different sensors connected to a rack PDU or Rack PDU Array™
Additionally it displays the configurable information for the following:
• Alarms for state of contacts (open, close) for sensors (door, contact sensor)
• Threshold values for the metered value sensors (temperature, humidity and pressure)
• Unit of display for temperature sensor in degrees Celsius or Fahrenheit
This command is available for an admin, appliance or poweruser.
sensor
Table 2.25 Syntax
Vertiv | RPC2™ Communications Module Command Reference Guide | 31
To Next Page
Loading...
