Vertiv RPC2 - PDU Explorer Settings Tab; Branch Settings Configuration

2.9 datalog
Type datalog to enable an admin to log all levels of PDUdata to a log file.
datalog
help
export_ftp
ipaddr <value>
username <value>
passwd <value>
filedir <value>
filename <value>
export_type
<type> (ftp)
flush
interval
<value> (5, 15, 30, 60 minutes)
perform_export
<level> (datalog, pdu, branch, receptacle)
enable
disable
Table 2.8 Syntax
Examples
To enable data logging at the PDUlevel, enter the following command.
cli->datalog pdu enable
To configure the data log polling interval for 30 minutes, enter the following command.
cli->datalog interval 30
To configure an FTPserver for data logging, enter the following commands.
cli->datalog export_ftp ipaddr <ip address>
cli->datalog export_ftp username <username>
cli->datalog export_ftp passwd <password>
Vertiv | RPC2™ Communications Module Command Reference Guide | 13