Vertiv RPC2 - Viewing BDM Sensor Details

Current time---------2000-01-01 08:49:20
NTP server-----------10.158.167.22
NTP Sync Rate--------24 Hours
To configure the IPaddress of the NTPserver, enter the following command.
cli->time ntp server <ip address>
To configure the local time, enter the following command.
cli->time local <yyyy-mm-dd hh:mm:ss>
2.39 unbalancedload
Type unbalancedload to permit an admin to view and configure the load alarm threshold for three-phase systems.
unbalancedload
help
threshold
<pdu>
<threshold_value>
Table 2.35 Syntax
Examples
To view the threshold for PDU 1, enter the following command.
cli->unbalancedload threshold
[1]---5
To configure the threshold for PDU2 to be at 50 percent, enter the following command.
cli->unbalancedload threshold 2 50
NOTE: If you try to view or configure a PDUthat is not a three-phase system, a No Support message is displayed.
Vertiv | RPC2™ Communications Module Command Reference Guide | 42