Vertiv RPC2 - PDU Explorer Sensors; Device Explorer Overview

<pdu.branch>
<pdu.branch.receptacle>
Examples
To view the energy for receptacle 4 of branch Aof PDU1, enter the following command.
cli->energy 1.A.4
[1.A] --- (4) 3.70 kWH
To reset the energy for receptacle 4 of branch Aof PDU1, enter the following command.
cli->energy reset 1.A.4
2.13 exit
Type exit to log out of the current session.
2.14 factorydefaults
Type factorydefaults to reset all PDUs to their factory default settings. The admin and appliance users have access to this
command.
2.15 fwupdate
Type fwupdate to enable an admin to update the firmware for the module.
fwupdate
help
update
source
<source type> (tftp, ftp)
ftp
ipaddr <value>
username <value>
passwd <value>
filedir <value>
filename <value>
tftp
ipaddr <value>
port <value>
filedir <value>
filename <value>
Table 2.12 Syntax
Vertiv | RPC2™ Communications Module Command Reference Guide | 16