<pdu.branch>
<pdu>
Examples
To view the status of PDU 2, enter the following command.
cli-> status 2
[2]
Over Current ----------------Normal
Under Current --------------Normal
Under Voltage---------------Normal
Unbalanced Load-----------65
Channel -----------------------Normal
To view the status of branch Bof PDU2, enter the following command.
cli-> status channel 2.B
[2] --- (B) Normal
2.32 swocp
Type swocp to enable or disable the software overcurrent protection (SWOCP)at the input or branch level in a rack PDU
or Rack PDU Array™. This command is available for an admin, appliance or poweruser.
swocp
help
<pdu>, <pdu.branch>
Table 2.28 Syntax
Vertiv | RPC2™ Communications Module Command Reference Guide | 36
To Next Page
Loading...
