Vertiv RPC2 - Installation and Configuration; Getting Started with Installation; Required Cables for Functionality

2 COMMANDS
This section lists and describes the commands available in the CLIfor the RPC2™ Communications Module.
Each command in this guide has a table. Each level of the table represents an argument level in the CLI. Arguments
contained within angle brackets (< >) are user-defined arguments. For example, the following table defines the user
command.
user
help
add
<user>
<password>
<confirm password>
del
<user>
<user>
Table 2.1 Syntax
The first argument in the command is always user.
cli->user
From there, you can access the context-sensitive help.
cli->user help
To add a user, you must define the username and password and confirm the password.
cli->user add <user><password><confirm password>
The add and delete arguments are on the same level as the help argument. The <user>, <password> and <confirm
password>arguments follow on separate levels.
2.1 Values
For some of the commands, you can set the values for a PDU, branch, receptacle or phase. The following are acceptable
values.
PDU:1-4
Branch:A-G
NOTE: When setting the value for a branch, you must use uppercase letters.
Receptacle:1-48
Phase:L1-L3, L12, L23, L31 or N for neutral phase
NOTE: Type @for either a branch or receptacle to set the values for all branches and receptacles.
Vertiv | RPC2™ Communications Module Command Reference Guide | 3