Vertiv RPC2 - RPC BDM Contrast Adjustment

max_session
name
session_timeout
snmp_mib_downloads
<interface>(snmp, webserver, velocity, telnet, ssh)
enable
disable
Examples
To view the agent boot version, enter the following command.
cli->system agent boot_version
To enable snmp, enter the following command.
cli->system snmp enable
2.37 tag
Type tag to display the configurable values for user-defined asset tags for an input, branch or receptacle levels. This
command is available for an admin, appliance or poweruser.
NOTE: There are two sets of tags (Tag#01, Tag#02) in Vertiv MPX™ and Vertiv MPH™ PDUs for every PDU, MPX
BRM™ and receptacle.
tag
help
<pdu>, <pdu.branch>, <pdu.branch.receptacle>
<tag>
<tagvalue>
Table 2.33 Syntax
Examples
To view the tag information for both tags for a receptacle 6 on branch Cof PDU2, enter the following command.
cli->tag 2.C.6 @
[2-C] --- (6-T1) PDU#2_BRN#C_RECP#6_TAG#01 (6-T2) PDU#2_BRN#C_RECP#6_TAG#02
To view just tag 2 for receptacle 6 on branch Cof PDU2, enter the following command.
cli->tag 2.c.6 2
Vertiv | RPC2™ Communications Module Command Reference Guide | 40