2.3 auth
Type auth to display the authentication configuration information of a rack PDU or Rack PDU Array™. An admin can
configure the authentication parameters.
auth
help
type
kerberos, kerberos_local, kerberos_down_local, ldap, ldap_local, ldap_down_local, local, local_radius, local_tacacs+, dsview, dsview_
local, radius, radius_local, radius_down_local, tacacs+, tacacs+_local, tacacs+_down_local
webmode
Form-base, Digest
remoteserver
dsview
<ipaddr1>, <ipaddr2>, <ipaddr3>, <ipaddr4>
radius
<firstauthadd>, <firstaccountaddr>, <secondauthaddr>, <secondaccountaddr>, <secret>, <confirmsecret>, <timeout>, <retries>
tacacs+
<firstauthaddr>, <firstaccountaddr>, <secondauthaddr>, <secondaccountaddr>, <service>, <secret>, <confirmsecret>,
<timeout>, <retries>, <version>
ldap_ad
<server>, <base>, <secure>, <username>, <password>, <cofirmpassword>, <loginattr>
kerberos
<realmserver>, <realmname>, <domainname>
Table 2.2 Syntax
Examples
To set the authentication type as DSView, enter the following command.
cli->auth type dsview
To configure the DSView remote server, enter the following command.
cli-> auth remoteserver dsview <IPAddress1> <IPAddress2> <IPAddress3> < IPAddress4>
2.4 backup_restore
Type backup_restore to display the backup and restore settings for the module. An admin can configure the settings.
backup_restore
help
restore
Table 2.3 Syntax
Vertiv | RPC2™ Communications Module Command Reference Guide | 6
To Next Page
Loading...
