Viavi MAP-200 - Page 96

Specifications
mOSW-C1 Parameters
MAP-200 Optical Switch mOSW-C1 Installation and User Guide Standard
June 2016 Document Number 22112369-120 R000 Page 96
Table 3: mOSW-C1 [1x2] and [2x2] Parameters
Parameter
10
1x2
2x2
Wavelength Range
Single Mode
11
(SM) 1290nm to 1330 and 1520 to 1650nm
Multi Mode
12
(MM) 760nm – 1360nm
Insertion Loss (IL)
13
Single Mode (SM) 0.7 dB 1.2 dB
Multi Mode (MM) 0.9 dB 1.2 dB
Return Loss (RL)
14
Single Mode (SM) 50 dB 50 dB
Multi Mode (MM), OM1 (62.5 µm) 30 dB 25 dB
Multi Mode (MM), OM3 (50 µm) 40 dB 35 dB
Polarization Dependent Loss (PDL)
15
Single Mode 0.07 dB 0.08 dB
Repeatability
16
SM and MM ±0.02 dB ±0.03 dB
Insertion Loss
IL Stability
17
(maximum) ±0.025 dB
Crosstalk (maximum)
Single Mode (SM) -55 dB
10
All optical measurements, excluding connectors, taken after temperature has been stabilized for minimum of one hour, at ambient
room temperature between 20-30°C and variation less than ±3°C.
11
For IEC 60793-2-50 Type B1.3/ ISO 11801 OS2 compliant fiber, that is Corning SMF-28e.
12
For fiber type of OM1 and OM3 fiber compliant with ISO/IEC 11801.
13
Excluding connectors. Tested at 1310nm and 1650nm for SM and 850nm and 1300nm for MM. EF compliant with IEC 62614 ED1.0
2010.
14
RL excluding the connectors with 1m pigtail length. Tested at 1310nm/1625nm for SM and 850nm/1300nm for MM. EF compliant with
IEC 62614 ED1.0 2010.
15
PDL tested at 1310nm and 1650nm.
16
Measured between two consecutive readings over 100 cycles.
17
Drift of any channel relative to reference channel at ±3°C deviation of ambient temperature over a 7-day period (168 hours).