29
TAB: 40507
EN
When the Voicemail function is activated, message recording is possible when the device receives calls from
entry panels or from other internal units.
On a Mobile device, with call forwarding enabled, it is not possible to record messages using the Call home
function. However, if an intercom call is made, message recording is possible.
To activate this function, simply press the relative button.
When the function is activated, the button will be highlighted and the icon
, will appear in the top bar as
shown in the image below.
To deactivate the function, simply press the Voicemail button again. The button will return to its original form and
the icon will disappear from the top bar.
The response time set on the entry panel or intercom is the time given to the user to answer the call. On intercom
calls the value is xed at 30 seconds, while on the entry panel, the user can set any value between 1 and 255
seconds.
You can set a voicemail time delay, i.e. the time allowed the user before the recording starts to play.
The two times should be coordinated to ensure that the call does not end before the voicemail function intervenes.
For this reason, on receipt of a call, the monitor asks the caller for the set answer time. If this is less than the
voicemail delay time, recording will start earlier.
Automatic opening (Professional Studio)
This function automatically opens the door when a call is received in one of the time periods set by the user (see
the chapter "Professional Studio" later on in this manual).
To activate this function, simply press the relative button.
When the function is activated, the button will be highlighted and the icon
, will appear in the top bar as
shown in the image below.
To Next Page
Loading...
Need help?
General
