Project area:
Device overview:
Module ... Slot ... Type ...
PLC ... 2 CPU 313C
MPI interface... 2 0 MPI interface
DP interface... 2 X2 DP interface
DI16/DO16... 2 2 DI16/DO16
Counter... 2 4 Counter
... ...
Since the CPU 313-6CF13 from VIPA is configured as Siemens CPU
313C-2DP, so the parametrization takes place via the Siemens CPU.
For parametrization click in the Project area respectively in the Device
overview at the CPU part. Then the parameters of the CPU part are
shown in the Properties dialog. Here you can make your parameter
settings.
Ä
Chapter 5.8 ‘CPU parametrization’ on page 53
10.3 TIA Portal - Hardware configuration - I/O modules
After the hardware configuration of the CPU place the System 300
modules at the bus in the plugged sequence. For this drag&drop the
according module from the Hardware catalog to the according posi-
tion of the profile rail in the Project area or in the Device overview
Setting standard CPU
parameters
Hardware configuration
of the modules
VIPA System 300S Configuration with TIA Portal
TIA Portal - Hardware configuration - I/O modules
HB140 | CPU-SC | 313-6CF13 | GB | 15-50 199
To Next Page
Loading...