Event-ID Description
0xEA11 SBUS: Output periphery address outside the periphery area
ZInfo1: Periphery address
ZInfo2: Slot
ZInfo3: Data width
0xEA12 SBUS: Error at writing record set
ZInfo1: Slot
ZInfo2: Record set number
ZInfo3: Record set length
0xEA14 SBUS: Multiple parametrization of a periphery address (diagnostics
address)
ZInfo1: Periphery address
ZInfo2: Slot
ZInfo3: Data width
0xEA15 Internal error - Please contact the VIPA Hotline!
0xEA18 SBUS: Error at mapping of the master periphery
ZInfo2: Slot of the master
0xEA19 Internal error - Please contact the VIPA Hotline!
0xEA20 Error - RS485 interface is not pre-set to PROFIBUS DP master bus a
PROFIBUS DP master is configured.
0xEA21 Error - Configuration RS485 interface X2/X3:
PROFIBUS DP master is configured but missing
ZInfo2: Interface x
0xEA22 Error - RS485 interface X2 - Value exceeds the limits
ZInfo: Configured value of X2
0xEA23 Error - RS485 interface X3 - Value exceeds the limits
ZInfo: Configured value of X3
0xEA24 Error - Configuration RS485 interface X2/X3:
Interface/protocol missing, default settings are used
ZInfo2: Configured value for X2
ZInfo3: Configured value for X3
0xEA30 Internal error - Please contact the VIPA Hotline!
0xEA40 Internal error - Please contact the VIPA Hotline!
0xEA41 Internal error - Please contact the VIPA Hotline!
0xEA50 Error - PROFINET configuration
ZInfo1: User slot of the PROFINET I/O controller
ZInfo2: IO-Device-No.
ZInfo3: IO-Device slot
VIPA System 300SDeployment CPU 313-6CF13
VIPA specific diagnostic entries
HB140 | CPU-SC | 313-6CF13 | GB | 15-50 84
To Next Page
Loading...