Visonic KP-250 PG2 - APPENDIX D: Compliance with Standards

APPENDIX D: Compliance with Standards
Europe: EN 300 220, EN 300 330, EN 301 489, EN 50130-4, EN 60950, EN 50130-5, EN
50131
-1, EN 50131-3, EN 50131-6.
The KP
-250 PG2 is compatible with the RED Directive2014/53/EU of the European
Parliament and of the Council of 16 April 2014.
The Power G peripheral devices have two
- way communication functionality, providing additional benefits as
described in the technical brochure. This functionality has not been tested to comply with the re
spective
technical requirements and should therefore be considered outside the scope of the product’s certification
Certified by
Applica T&C in accordance with EN 50131.
UK:
This product is suitable for use in systems installed to conform to PD6662:2010 at
Grade 2 and environmental CLASS II. DD243 and BS8243
Security Grade:
Grade 2
Environmental Class:
Class II
USA:
CFR 47 part 15
Canada: RSS 210
This device complies with FCC Rules Part 15 and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the mobile version of this device should be located at a
distance of at least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in
conjunction with any other antenna or transmitter.
Le dispositif doit être placé à une distance d'au moins 20 cm à partir de toutes les personnes au cours de son fonctionnement normal. Les
antennes utilisées pour ce produit ne doivent pas être situés ou exploités conjointement avec une autre antenne ou transmetteur.
The digital circuit of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference
by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
Changes or modifications not expressly approved by Visonic Ltd. could void the user's authority to operate the equipment.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased
it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your
supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
D-306919 KP-250 PG2 Installer’s Guide 97