Visonic KP-250 PG2 - 6 Reading the Event Log

Fault What it means Solution
SOAK TEST FAIL
Detector alarms when in Soak Test
mode
If you wish to continue the Soak Test,
no further action should be taken.
If you wish to abort the Soak Test,
disable the Soak Test (see section
3.4.6).
6. Reading the Event Log
Up to 100 events are stored in the event log. You can access this log and review the events, one by one. If the event log
fills up completely, the oldest event is deleted upon registration of each new event. The date and time of occurrence are
memorized for each event.
Note: Up to 1000 events are stored in the event log that can be reviewed via the Remote Programmer PC software
application or by the remote PowerManage server.
When reading the event log, events are shown in chronological order, from the newest to the oldest. Access to the event
log is provided by clicking the button (not through the installer’s menu). The reading and erasing process of the
event log is shown in the following table:
Step 1

Step 2

Step 3

In normal operating mode
[1]
Enter Installer Code
[2]
Reviewing Events
[3]
00:00 READY
PRESENT TAG OR
ENTER CODE

KP-250
LIST OF EVENTS
Z13 ALARM
09/02/11 3:37 P
Step 4

Step 5

Step 6

Scroll List of Events
[4]
CLEAR EVENT LOG display
[5]
Erase the Event Log
[6]
➯
SR2 TAMPER ALARM
07/02/11 11:49 A
CLEAR EVENT LOG
KP-250
<DEL> to Delete
Step 7

Step 8

Event Log is erased [7]
Returns to normal operating
mode
[8]

KP-250
<OK> to Exit
00:00 READY


- Reading Events
[1]
While the system is in the normal operating mode, press the key.
D-306919 KP-250 PG2 Installer’s Guide 89