Visonic KP-250 PG2 Installer's Guide

3.2 Entering the "Installer Mode" and Selecting a Menu Option
All installer menu options can be accessed via the "Installer Mode" on the KP-250 PG2 keypad which is one of the
main system menu options. The display on the keypad is on two rows.
To enter the "Installer Mode" and select an Installer Menu Option, complete the following steps:
Step 1

Step 2

Step 3
Select "INSTALLER MODE"
Option
[1]
Enter Installer Code
[2]
Select "Installer Menu" Option


See
HH:MM READY
01:INSTALL CODES
3.3

02:ZONES/DEVICES
3.4
INSTALLER
MODE
ENTER CODE:

03:CONTROL PANEL
3.5
If the "Installer Mode" is
not shown, refer to section
3.2.1
04:COMMUNICATION
3.6
05:OUTPUTS
3.7
06:CUSTOM NAMES
3.8
07:DIAGNOSTICS
3.9
08:USER SETTINGS
3.10
09:FACTORY DEFLT
3.11
10:SERIAL NUMBER
3.12
12:PARTITIONING
enable
3.13
13:OPERATION MODE
3.14
<OK> to Exit


- Entering the "Installer Mode" menu
[1]
You can access the "Installer Mode" only when the system is disarmed. The process described refers to the
case where "User permit" is not required. If "User permit" is required, select the "User Settings" option and
ask the Master User to enter his code and then scroll the "User Settings" menu and select the "Installer Mode"
option (last option in the menu). Continue to Step 2.
[2]
If you have not already changed your Installer code number, use the default settings: 8888 for installer & 9999 for
master installer.
If you enter an invalid installer code 5 times, the keypad will be automatically disabled for a pre-defined period of
time and the message WRONG PASSWORD will be displayed.
[3]
You have now entered the "Installer Menu". Scroll and select the menu you wish and continue to its
corresponding section in the guide (indicated on the right side of each option).
10 D-306919 KP-250 PG2 Installer’s Guide

Visonic KP-250 PG2 Specifications

General

Brand	Visonic
Model	KP-250 PG2
Category	Keypad
Language	English