Visonic KP-250 PG2 Installer's Guide

3.13.2 Enabling / Disabling Partitions
To enable or disable the partition feature, complete the following steps:
Step 1 Step 2
Step 3
Select "12:PARTITIONING" menu
Select whether to "Enable" or
"Disable" Partitions


Partitions are now enabled
12:PARTITIONING
disable
12:PARTITIONING
disable
12:PARTITIONING
enabled

12:PARTITIONING
enabled
Step 4
Press to return to
“12:PARTITIONING” or to
take you to “<OK> to Exit”.
3.14 Operation Mode
Note: The Operation Mode feature is applicable only in specific PowerMaster variants.
3.14.1 General Guidance – "Operation Mode" Menu
This mode allows you to select an operation mode for the control panel according to specific compliance standards. Each
operation mode has its own configuration.
3.14.2 Select Setting
To select the desired operation mode, complete the following steps:
Step 1 Step 2 Step 3
Step 4
Select "13:OPERATION MOD"
menu
Enter "01:SELECT MODE"
Select between “normal
1
”,
"EN-50131", "DD243", "BS8243",
“
Incert
1
" and “
CP01
1
”
  
13:OPERATION MODE
01:SELECT MODE
normal
01:SELECT MODE
normal

to
Step 1
Note: If "normal / EN-50131 / INCERT" is selected, the control panel will operate according to the OTHERS setup
configuration (see section 3.14.6).
1
The following options normal, Incert, and CP01 are not available for all configurations.
74 D-306919 KP-250 PG2 Installer’s Guide

Visonic KP-250 PG2 Specifications

General

Brand	Visonic
Model	KP-250 PG2
Category	Keypad
Language	English