Visonic KP-250 PG2 - Defining Configuration Defaults for Device Settings

3.4.7 Defining Configuration Defaults for "Device Settings"
KP-250 PG2 enables you to define the Default Parameters used during enrollment and to change them whenever you
wish so that new devices enrolled into the system will be configured automatically with these default parameters without
the need to modify the configuration of each new enrolled device. You can use a certain set of defaults for certain group
of devices and then change the defaults for another group.
IMPORTANT! Devices that were already enrolled in the alarm system before the defaults have been changed will not
be affected by the new default settings.
To Define the Default parameters of a device Group, complete the following steps:
Step 1

Step 2

Step 3

Select "DEFINE DEFAULTS"
Option
[1]
Select the respective device
Group
[2]
Select the Default Parameter
[3]



02:ZONES/DEVICES
CONTACT SENSORS


DEFINE DEFAULTS
MOTION SENSORS
Alarm LED
on

EVENT COUNTER
low

DISARM ACTIVITY
Not Active

Step 4

Step 5

Select the new Default Setting
[4]
[5]

EVENT COUNTER
low
See  [5]

to Step 3

EVENT COUNTER
high

D-306919 KP-250 PG2 Installer’s Guide 23