Visonic KP-250 PG2 - Testing the GSM Module

Option Instructions
At the end of the test process, the KP-250 PG2 will present the devices' status:
"Zxx: 24hr: <status>"
8
"Zxx: NOW: <status>"
1
.
Note: Refer to "SHOW ALL DEVICES" section for further information on device
status.
SHOW ALL DEVICES
You can view the devices status.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screen will appear:
"Zxx: 24hr: <status>"
1
"Zxx: NOW: <status>"
1
Use to scroll between the device's families.
SHOW RF PROBLEMS
You can view only the devices which have RF problems.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screen will appear:
"Zxx: 24hr: <status>"
1
"Zxx: NOW: <status>"
1
Use to scroll between the device's families.
<OK> to exit
Select to terminate the diagnostics test.
3.9.3 Testing the GSM module
The KP-250 PG2 enables to test the GSM module integrated inside the panel.
07:DIAGNOSTICS
⋅⋅⋅
GSM/GPRS PLEASE WAIT..
Enter the "GSM/GPRS" menu, and press to initiate the GSM diagnostic test. Upon test completion, the KP-250
PG2 will present the test result.
The following table presents the test result messages
Message
Description
Unit is OK GSM / GPRS is functioning correctly
GSM com. loss GSM/GPRS module does not communicate with the Panel
8
The signal strength indications are as follows: "STRONG"; GOOD"; "POOR"; "1-WAY" (the device operates in 1-way
mode or, the "NOW" communication test failed); "NOT TST" (results are shown without any performed test); "NOT
NET" [device is not networked (not fully enrolled)]; "NONE" (keyfob 24Hr result); or "EARLY" (result of the last 24Hrs
without statistics).
D-306919 KP-250 PG2 Installer’s Guide 67