Visonic KP-250 PG2 - Maintenance; Replacing Wireless Devices Batteries; Event Log Review

Option and default Configuration Instructions
return.
Remote access
enable
Enable or disable the remote access to the system. If disabled, the system cannot be
accessed remotely thereby inhibiting the Upload/Download and the Remote Control via
PSTN or GSM analog communication channels (refer to the KP-250 PG2 User's Guide,
Chapter 7).
Options: enable; disable.
Mast. UL/DL code
Enter the 4-digit password (Master Installer download code) code that will allow the
Master Installer to access the system remotely and upload/download data to the
PowerMaster panel.
Note: "0000" is not a valid code and must not be used.
Inst. UL/DL code
Enter the 4-digit password (Installer download code) code that will allow the Installer to
access the system from remote and upload or download data into the PowerMaster
panel.
Notes: "0000" is not a valid code and must not be used.
The installer can configure via UL/DL only the options he is authorized to configure from
the control panel.
UL/DL modes
in DISARM only
Define whether the downloading/uploading can be performed in Disarm mode (state) only
or in all modes (i.e. Away, Home & Disarm).
(Return)
Options: in all modes or in DISARM only.
GPRS/UP DOWNLOAD
Configure the Upload/Download functionality via GPRS. The functionality is
determined through a sub-menu of the "GPRS UP/DOWNLOAD" option as shown
below.
To program:
Press to enter the "GPRS UP/DOWNLOAD" sub menu and then select and
configure each of the sub-menu options as shown below. When done, press to
return.
Panel SIM Tel#
Enter the PowerMaster SIM card telephone number. The PowerManage server at the
Monitoring Station sends an SMS message to this number for the panel to call back the
PowerManage server via GPRS for initiating the uploading / downloading process.
(Previously known as "My
SIM Tel.#")
Enter the SIM card telephone number of the panel's GSM module.
1st caller ID#
Enter the "Caller ID" (i.e. telephone number) from which Monitoring Station #1 (C.S.1)
/ Monitoring Station #2 (C.S.2) calls the control panel for initiating the Up/Download
process. If the sender's Caller ID matches with the "1
st
caller ID#" / "2
nd
caller ID#", the
52 D-306919 KP-250 PG2 Installer’s Guide