Visonic KP-250 PG2 - Page 67

Option Description of Option Features and Parameters Section
WL DEVICES
Describes how to test the devices attached to the PowerMaster panel,
review devices' status and RF signal status. You can test all devices, test
single device, review devices status and review RF problems, in case of
any.
3.9.2
GSM/GPRS
Describes how to test the GSM/GPRS/SIM communication module.
3.9.3
SIM NUMBER TEST
Tests the SIM number to ensure correct entry of the SIM number in the
control panel.
3.9.4
BROADBAND MODULE
Enables to test the communication of the Broadband Module with the
PowerManage server.
3.9.5
EXPANDER TEST
(PM-33 only)
View the catalog number and SW version of the enrolled HW IOV devices.
This is required in order to confirm successful SW upgrade of the HW IOV
devices.
FIND ME
(PM-33 only)
Command any enrolled HW/WL IOV device to sound a tone.
To enter the "07.DIAGNOSTICS" menu and to select and configure an option, complete the following steps:
Step 1
Select "COMMUNICATION"

INSTALLER MODE

7.DIAGNOSTICS
Step 2
Step 3
Select sub-menu option
Select the diagnostics you want to perform



WL DEVICES
TEST ALL DEVICES
TEST ALL DEVICES

SHOW ALL DEVICES
SHOW RF PROBLEMS
TEST ONE DEVICE
MOTION SENSORS

SHOCK SENSORS
64 D-306919 KP-250 PG2 Installer’s Guide