95x Series Operating Manual - May 17, 2022
Page 153 of 155
MIGRATING FROM EARLIER FIRMWARE VERSIONS
NOTE – if the user upgrades their 95x from an earlier version to v2.02 then a self-test MUST be run after the
upgrade and before attempting to operate the 95x (see Self Test).
NOTE – users of QuickTest Pro need not make any changes to either the 95x, QuickTest Pro or their test sequences
because of these changes. An updated version of QuickTest Pro using some of the new features may be available,
contact Vitrek for details.
If the user has been using an earlier version of firmware in a 95x and is now using v2.02 then there are some
differences which the user should be aware of –
• Added additional bit values to the Test Status Flags data which may be read via an interface during or
after a sequence has been run (see
To Next Page
Loading...
