EmbryoScope time-lapse incubator
- 44 -
7.3 Temperature check
To perform a temperature validation check, start by opening the load door of the EmbryoScope
time-lapse incubator. The temperature is validated by inserting a calibrated temperature sensor
into the culture dish holder. Any certified temperature sensor with proper sensor dimensions may
be used in accordance with the manufacturer’s guidelines. However, a special socket in the culture
dish holder is designed for use with a microsensor connected to a high-precision thermometer (for
information on how to validate the temperature, see section 5.4.2).
Press Next when the validation of the temperature is complete.
To Next Page
Loading...