EmbryoScope time-lapse incubator
- 59 -
9.4.2 Warning information signals
The EmbryoScope time-lapse incubator will issue a warning information signal if:
• The integrated PC has been in error for more than five minutes.
• The software integrated in the EmbryoScope time-lapse incubator is not running.
• The connection between the incubator and the integrated PC has been interrupted
(possibly because the integrated PC is shut down).
• The load door to the embryo chamber has been left open. The information signal will be
activated after 30 seconds.
• The EmbryoScope time-lapse incubator has been paused for more than one hour without
reinsertion of an EmbryoSlide culture dish.
• The EmbryoScope time-lapse incubator has been left in Check mode for more than half an
hour.
To Next Page
Loading...