69
Remote Control Interface
The Remote control interface section describes how to set up the
USB interface for PC connection. The details of remote control
commands are described in the DSO-4000 Programming Manual.
PC side
Type A, host
USB connection
DSO-4000 side
Type B, slave
Speed
1.1/2.0 (full speed)
Procedure
1. Connect the USB cable to
the USB slave port.
2. When the PC asks for the USB driver, select
dso_cdc_1000.inf which is downloadable from
the attached CD-R.
3. On the PC, activate a terminal application such
as MTTTY (Multi-Threaded TTY). To check the
COM port No., see the Device Manager in the
PC. For WindowsXP, select Control panel →
System → Hardware tab.
4. Run this query command via the terminal
application.
*idn?
This command should return the manufacturer,
model number, serial number, and firmware
version in the following format.
Conrad, DSO-4xxx, 000000001, V1.00
5. Configuring the command interface is
completed. Refer to the programming manual
for the remote commands and other details.
DSO-4000 User Manual
70
System Settings
The system settings show the oscilloscope’s system information and
allow changing the language.
Viewing the system information
Procedure
1. Press the Utility key.
Utility
2. Press More.
3. Press System Info. The upper
half of the display shows the
following information.
System
Info.
• Manufacturer • Model
• Serial number • Firmware version
4. Press any other key to go
back to the waveform
display mode.
Previous
Menu
Selecting the language
Parameter
Language selection differs according to the region
to which the oscilloscope is shipped.
• English • Chinese (traditional)
• Chinese (simplified) • Others
Procedure
1. Press the Utility key.
Utility
2. Press Language repeatedly to
select the language.
To Next Page
Loading...