With "Constant engine speed control" the idle can be
temporarily raised, so that it is higher while the power
take-off is being used. The idling speed can be raised
by different amounts, depending on which type of
power take-off is installed in the truck.
Note!
Never set the engine speed higher
than the body builder's
recommendation. See information
from the body builder.
Engine-mounted power take-off
Engine-mounted power take-offs can be engaged or
disengaged while travelling without depressing the
clutch.
On trucks with I-shift it will not be possible to change
gear if the power take-off is engaged while driving.
The desired gear must be selected while the truck is
stationary.
The engine speed is limited when engine-mounted
hydraulic pumps are used.
J3015780
J3015781
Clutch-independent PTO
Non clutch-dependent power take-off can be engaged
or disengaged while travelling without depressing the
clutch. Do not switch in the power take-off at engine
speeds exceeding
1200 rpm
.
Non clutch-dependent power take-off can be used
during driving and when the gearbox is not engaged.
Non clutch-dependent power take-off can be engaged
or disengaged while travelling without depressing the
clutch. Do not switch in the power take-off at engine
speeds exceeding
1000 rpm
.
J0008084
Driving
177
To Next Page
Loading...
