12
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2357061
2.3.3 ACCESSORIES
Remote control
The remote control may be used in potentially explosive areas (zone 1 and 2).
See chapter 6.5.
Alarm horn
The alarm horn may be used in potentially explosive areas (zone 1 and 2).
2.4 PROCESSIBLE WORKING MATERIALS
Low-viscosity to high-viscosity 2K/3K/4K lacquers (e.g., epoxy, PU, DD) with a pot life of
more than 5 minutes.
− 2K water-based primer − 2K epoxy primer
− 2K solvent-based primer − 2K epoxy lacquers
− 2K PUR primer − 2K high solid primer
− 2K PUR lacquers − 2K high solid lacquers
− 3K and 4K combinations of above products
Solvent and water-based 2K products should not be processed using the same
system.
NOTICE
Abrasive working materials and pigments!
Greater wear of parts carrying the product.
Do not use any grainy and abrasive working materials with large, sharp-edged
pigments.
Use application-oriented pumps (ow rate/cycle, product, valves, etc.).
Check if the uids and solvents used are compatible with the pump construction
materials.
For explanations of the models and construction materials, consult the technical
data in Chapters 5.5.4 as well as the operating manuals for the pumps and valves or
contact a WAGNER service technician.
Wear caused by abrasive working materials is not covered by the warranty.
Materials in direct contact with the products
Stainless steel Carbide PTFE PE (UHMWPE)
2.5 MISUSE
Misuse can lead to physical injury and/or property damage!
Special attention must be paid that:
No dry coating products, e.g. powder are processed;
No food, medicine or cosmetics are processed.
To Next Page
Loading...