80
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2357061
8.6 FLUSHING
DANGER
Exploding gas / air mixture!
Danger to life from ying parts and burns.
Never spray into a closed tank.
Ground the tank.
If a high-pressure gun is used, remove the spray nozzle before ushing.
−
The pressure has to be relieved before removing the spray nozzle (see Chapter 8.8).
Wear protective goggles.
Apply the lowest possible product pressure for ushing so that the maximum ow rate
of the ow meter is not exceeded.
WARNING
High-pressure spray jet!
Danger to life from injecting paint or solvent.
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused by paint or solvent.
Inform the doctor about the paint or solvent used.
Never seal defective high-pressure parts; instead relieve the pressure from them and
replace them immediately.
Use personal protective equipment (protective clothing, gloves, eyewear and respiratory
protection).
The system has to be ushed:
in case of recipe change (recipe change ushing, system ushes automatically);
in case of extended interruption of work or end of work (end ushing);
if pot life has been exceeded (end ushing).
WARNING
Discharge of the electrostatics in atmospheres containing solvents!
Fire and explosion hazard.
Turn o the electrostatics before ushing the gun or before placing the gun in the
gun ush box.
To Next Page
Loading...