WAGNER 2K COMFORT - 7 Controller; Training the Operating Staff; Safety Instructions

52
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2357061
7 CONTROLLER
7.1 TRAINING THE OPERATING STAFF
The operating sta must be qualied to operate the entire system.
The operating sta must be familiar with the potential risks associated with improper
behavior as well as the necessary protective devices and measures.
Before work commences, the operating sta must receive appropriate system training.
7.2 SAFETY INSTRUCTIONS
Before carrying out any work, ensure that commissioning is carried out in accordance with
Chapter 6.6.
WARNING
Incorrect operation!
Risk of injury and damage to the device.
If contact with lacquers or cleaning agents causes skin irritation, appropriate
precautionary measures must be taken, e.g., wearing protective clothing.
The footwear worn by operating sta must comply with EN ISO 20344. The measured
insulation resistance must not exceed 100megohms.
The protective clothing, including gloves, must comply with ENISO 1149-5. The measured
insulation resistance must not exceed 100 megohms.
WARNING
Unintentional putting into operation!
Risk of injury.
Before any work on the device, in the event of work interruptions and malfunctions:
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
Switch o the energy/compressed air supply.
Disconnect the control unit from the mains.
In the event of functional faults: remedy the fault as described in the "Troubleshooting"
chapter.