41
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2357061
6 ASSEMBLY AND COMMISSIONING
6.1 TRAINING OF ASSEMBLY/COMMISSIONING STAFF
The assembly and commissioning sta must have the technical skills to safely commission
the device.
When assembling, commissioning and carrying out all work, read and follow the
operating manuals and safety regulations for the additionally required system
components.
A skilled person must check to ensure that the device is in a reliable state after it is installed
and commissioned.
6.2 STORAGE AND INSTALLATION CONDITIONS
Until the point of assembly, the device must be stored in a dry location, free from vibrations
and with a minimum of dust. The device must be stored in closed rooms.
For ambient temperature and air humidity, see Chapter 5.5.1.
Long-term storage
See chapter 9.1.6.
For recommissioning, proceed according to following chapters.
6.3 TRANSPORTATION
The system can be transported in the specially designed transportation box.
System Unit Length Width Height
Non-Ex System mm; inch 1,800; 70.9 1,178; 46.4 400; 15.75
Ex System mm; inch 1,800; 70.9 1,178; 46.4 800; 31.5
2-circuit
(1 separate uid section)
mm; inch 1,800; 70.9 1,178; 46.4 800; 31.5
2-circuit
(2 separate uid sections)
mm; inch 1,800; 70.9 1,178; 46.4 1,200; 47.25
XL mm; inch 1,800; 70.9 1,178; 46.4 800; 31.5
6.4 ASSEMBLY AND INSTALLATION
The mixing units are normally installed by WAGNER technicians directly or by their agents.
If this is not the case, the material has to be checked for damage on receipt of the system.
WARNING
Inclined ground!
Risk of accidents if the device rolls away/falls.
Place the device on horizontal oor.
Rollers should be locked in position or replaced by leveling feet and secured.
Do not tilt the device during shifting / transporting.
To Next Page
Loading...